Controls, Indicators, And Connectors - Sony SRX-S110 Installation Manual

2-3. Controls, indicators, and connectors

Front/Top
1 2
4 5 6 7 8
Left side/Rear
1 2
3
4 5 6
3
DVI-D AUX
7 8 9 0 qa qs
2
Overview of the SRX-series Projectors
Remote Commander detector (front)
1
Upper side ventilation holes (intake)
2
Upper side ventilation holes (exhaust)
3
Adjusters: Used to keep the projector level if it is
4
installed on an uneven surface.
Lens cover
5
Lens mount adaptor
6
Carrying handle (there is another handle on the
7
rear side.)
Front/right side ventilation holes (intake)
8
Cooling unit: A cooling fan and the two lamp
1
houses are installed here.
Upper/rear side ventilation holes (exhaust)
2
Remote controller detector (rear)
3
Power switch: Upper is ON, and lower is OFF.
4
AC IN terminal board: Connect the AC power cord
5
with three wires (not supplied).
STATUS MESSAGE window: Displays error
6
messages.
STATUS LAMP indicator:
7
•Red: standby mode
•Green: Power on
•This flashes for about 10 minutes after the
power is turned off using the Remote
Commander™ unit or the SRX Controller
software.
INTER LOCK jack (minijack): Used to connect to an
8
external emergency switch.
Ethernet connector (10Base-T/100Base-TX)
9
RS-232C connector (D-sub 9-pin, female)
0
Input board attachment parts: Optional boards can
qa
be installed here. The SRX-S110/S105 is equipped
with DVI-D connector and AUX connector, and
three available slots here. The SRX-R110/R105 has
four available slots here.
INPUT A (DVI interface board pre-installed at the
qs
factory)(SRX-S110/S105 only)
•DVI-D connector (24-pin DVI connector, male):
For progressive DVI signal input.
•AUX connector (24-pin DVI connector, male):
Used for input extension.
7