Removal And Replacement Procedures; Component Replacement Procedures; Bottom Cover - HP ENVY Maintenance And Service Manual

5

Removal and replacement procedures

CAUTION:
Accessing these parts can damage the computer or void the warranty.

Component replacement procedures

NOTE: Details about the computer, including model, serial number, product key, and length of warranty, are
on the service tag one the bottom of the computer. See
There are as many as 61 screws that must be removed, replaced, and/or loosened when servicing the
computer. Make special note of each screw size and location during removal and replacement.

Bottom cover

NOTE: The bottom cover spare part kit includes two rear rubber feet, one front rubber foot, speaker grilles,
shielding, and retention brackets.
Description
Bottom cover (includes two rear rubber feet, one front rubber foot, speaker grilles, shielding, and
retention brackets)
Before disassembling the computer, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
Remove the bottom cover:
1. Remove the bottom cover rear rubber feet (1).
The bottom cover rear rubber feet are available using spare part number 829307-001.
26 Chapter 5 Removal and replacement procedures
Components described in this chapter should only be accessed by an authorized service provider.
Bottom on page 11 for details.
Spare part number
829289-001 and
848658-001