HP ENVY Maintenance And Service Manual page 40

1. Remove the Phillips PM2.0×2.6 broad head screw (1) that secures the solid-state drive/WLAN module
bracket to the keyboard/top cover.
2. Remove the solid-state drive/WLAN module bracket (2).
The solid-state drive/WLAN module bracket is included in the Solid-state Drive Hardware Kit, spare part
number 829300-001.
3. Lift the edge of the solid-state drive (1) opposite of the slot until it rests at an angle.
4. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
30 Chapter 5 Removal and replacement procedures