HP ENVY Maintenance And Service Manual page 37

2. Remove the eight Phillips PM2.5×5.5 screws (2) that secure the bottom cover to the computer.
3. Remove the three Phillips PM2.5×3.4 screws that secure the bottom cover to the computer.
4. Insert a case utility tool (1) or similar plastic, flat-tipped tool between the front edge of the
bottom cover and keyboard/top cover.
5. Separate the front edge (2) of the bottom cover from keyboard/top cover.
6. Remove the bottom cover (3).
NOTE: If it is necessary to replace the bottom cover, be sure to remove the bottom cover retention
brackets from the defective bottom cover and install them on the replacement bottom cover.
To remove the bottom cover retention brackets:
Component replacement procedures 27