Solid-State Drive - HP ENVY Maintenance And Service Manual

4. Remove the battery (4).
Reverse this procedure to install the battery.

Solid-state drive

Description
512-MB, M2, SATA-3, supporting TLC
256-MB, M2, SATA-3, supporting TLC
128-MB, M2, SATA-3, supporting TLC
128-MB, M2.2280, SATA-3
Solid-state Drive Hardware Kit
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
Bottom cover on page 26).
Spare part number
814224-001
812708-001
820547-001
829985-001
829300-001
Battery on page 28).
Component replacement procedures 29