Table of Contents
Advertisement
5
Removal and replacement procedures
NOTE:
This chapter provides removal and replacement procedures for Authorized Service Provider only
components. Components described in this chapter should only be accessed by an authorized service
provider. Accessing these components can damage the computer or void the warranty.
There are as many as 51 screws that must be removed, replaced, and/or loosened when servicing
the computer. Make special note of each screw size and location during removal and replacement.
NOTE:
HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
Keyboard/top cover
Description
Keyboard/top cover for use only in Latin America (includes the keyboard cable, TouchPad,
and TouchPad cable)
Before disassembling the computer, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
Remove the keyboard/top cover:
1.
Close the computer.
2.
Turn the computer upside down with the front toward you.
3.
Remove the following components:
(1) Two bottom cover rear feet
(2) Two rubber screw plugs
(3) One rubber screw cover
(4) Two plastic screw covers
The bottom cover rear feet, screw plugs, and screws covers are included in the Rubber Kit, spare part
number 855342-001.
Spare part number
855343-161
Keyboard/top cover
21
Advertisement
Table of Contents
