PIAGGIO MSS X10 500ie Executive Service Station Manual page 29

MSS X10 500ie Executive
SPARK PLUGS MUST BE REMOVED WHEN THE ENGINE
IS COLD. SPARK PLUGS MAINTENANCE OPERATIONS
ARE DESCRIBED IN THE SCHEDULED MAINTENANCE
TABLE. USING NON-CONFORMING ELECTRONIC CEN-
TRAL UNITS AND ELECTRONIC IGNITIONS OR SPARK
PLUGS OTHER THAN THOSE PRESCRIBED MAY SERI-
OUSLY DAMAGE THE ENGINE.
N.B.
USE OF SPARK PLUGS OTHER THAN THE INDICATED
TYPE OR UNSHIELDED SPARK PLUG CAPS CAN LEAD
TO FAULTS IN THE VEHICLE 'S ELECTRICAL SYSTEM.
Characteristic
Spark plug
NGK CR7EKB
WHEN REFITTING THE ACCESS DOOR, PAY ATTENTION TO THE FITTING FINS REQUIRED FOR
THE CORRECT POSITIONING AND FIXING OF THE SAME DOOR.
Check
-Place the vehicle on the centre stand on flat
ground;
- Remove the oil dipstick «A», dry it with a clean
cloth and put it back into its hole tightening it
completely;
Remove the dipstick and check that the oil level is
slightly over the second notch starting from the
lower end; if the level is below the MAX mark, it
needs to be filled up with the right amount of hub
oil.
-Screw up the oil dipstick again and make sure it
is locked properly into place.
Maintenance
MAIN - 29