PIAGGIO MSS X10 500ie Executive Service Station Manual page 179

MSS X10 500ie Executive
See also
Removal
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque,
and apply the recommended product.
- Fit the calliper on its support, tightening the two
screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE
CALLIPER ON THE DISC DURING FITTING, GENTLY EX-
PAND THE PADS.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Rear brake calliper fixing screws
tening pin
19.6 to 24.5
Pad fas-
41 - 51
Braking system
BRAK SYS - 179