PIAGGIO MSS X10 500ie Executive Service Station Manual page 143

MSS X10 500ie Executive
PAY PARTICULAR ATTENTION TO THE FIT-
TING OF THE SPEED SENSOR; PROCEED AS
FOLLOWS:
- install the speed sensor with its washer.
- Measure the height «X» with the aid of a feeler
gauge and check that its value is correct.
X = 0.4 to 1.65 mm
- If the measurement «X» is too large, remove the
washer and measure again.
Locking torques (N*m)
Front wheel speed sensor fastener screw
Refitting
- Fit the lower steering bearing on the steering
tube.
- Fit the fork together with the lower steering bear-
ing on the headstock and hold it so that it does not
fall.
N.B.
LUBRICATE THE STEERING FIFTH WHEEL TRACKS WITH
RECOMMENDED GREASE BEFORE USE.
Recommended products
AGIP GREASE PV2 Ivory smooth-textured,
slightly-stringy anhydrous calcium-base
grease.
TL 9150 066, NATO G 460 symbol
- Fit the upper steering bearing.
CAUTION
INSERT THE UPPER STEERING BEARING WITH THE
CAGE FACING UPWARDS.
6 - 8
Suspensions
SUSP - 143