PIAGGIO MSS X10 500ie Executive Service Station Manual page 178

Braking system
Refitting
Per il montaggio operare come descritto di segui-
to:
- Inserire le due pastiglie all'interno della pinza.
- Avendo cura di posizionare correttamente la mol-
la di ritegno, avvitare il perno di bloccaggio pasti-
glie alla giusta coppia di bloccaggio applicando il
prodotto consigliato.
- Procedere con il montaggio della pinza sul pro-
prio supporto serrando le due viti alla coppia pre-
scritta.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE
CALLIPER ON THE DISC DURING FITTING, GENTLY EX-
PAND THE PADS.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Screw tightening calliper to support
fastening pin
19.6 to 24.5
Removal
- Remove the rear brake calliper
- Loosen the two pins shown in the figure that lock
the two pads; be careful with the pad spring clamp.
- Remove the brake pads and check there are no
faults or warping. Replace it if such anomalies are
present.
- Check the thickness of the friction material is
more than 1.5 mm. If it is not, replace it
- The replacement must be made with greater re-
sidual thickness if the brake pad has not worn
evenly. A 0.5 mm thickness difference in the re-
sidual friction material is permitted.
BRAK SYS - 178
Pad
20 ÷ 25
MSS X10 500ie Executive