Description Of Each Component - Toshiba e-studio 555 Quick Start Manual

Chapter 1 PREPARATIONS

Description of Each Component

This section describes the names and operations of the components and options.
Front / Right side
10
1.
Reversing automatic document feeder
The stack of originals is scanned one sheet at a time. Both
sides of the original can be scanned. A maximum of 00
originals (80 g/m
or 0.62") can be placed in one go. (The maximum number
of sheets that can be set may vary depending on the
media type of the originals.)
2.
Operator's manual pocket (back)
Keep the manual in this pocket.
3.
Bypass tray
Use this to perform printing on special media types such
as OHP film, etc.
4.
Bypass cover
Open it when a paper jam occurs.
5.
Paper feed cover
Open this cover when releasing paper misfed in the
drawer feeding area.
6.
Paper size indicator

9
7
8
or 20 lb. Bond) (or stack height 6 mm
2
1
2
3
4
5
6
7.
Drawer
A maximum of 550 sheets (6 g/m
sheets (80 g/m
placed in one go.
8.
Tandem large capacity feeder
A maximum of 3000 sheets (6 g/m
sheets (80 g/m
in one go.
9.
Front cover
Open it when a paper jam occurs in the transfer/transport
unit.
10.
Toner cover
Open this cover when replacing the toner cartridge.
11.
Network interface connector
Use this connector when connecting this equipment to a
network.
12.
USB terminal (4-pin)
Use this terminal when connecting this equipment to a PC
with a commercially available USB cable.
12
11
or  lb. Bond) or 500
2
or 20 lb. Bond) of plain paper can be
2
,  lb. Bond) or 2500
2
, 20 lb. Bond) of plain paper can be placed
2