Toshiba e-studio 555 Quick Start Manual page 27

Saving energy when not in use – energy saving modes -
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Energy saving Procedure to switch
modes
When a specified period of
Automatic Energy time has passed since
*
Save mode the last use of the
equipment.
When the [ENERGY SAVER]
button is pressed or
*
Sleep mode when a specified period of
time has passed since the
*2
last use of the equipment.
When the [ENERGY SAVER]
button or the [POWER]
*
button is pressed or
*6
when a specified period of
Super Sleep mode
time has passed since the
*2
last use of the equipment.
*1 The default value set at the factory shipment is 3 minutes for e-STUDIO555 and 5 minutes for e-STUDIO655/755/855.
*2 The default value set at the factory shipment is 3 minutes for e-STUDIO555 and 10 minutes for e-STUDIO655/755/855.
*3 Any of the Wireless LAN Module, Bluetooth Module, Data overwrite enabler and e-BRIDGE ID Gate.
Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled, the equipment enters into the Sleep mode. Refer to the TopAccess
*4
Guide for details.
*5 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*6 Even if you press the [Power] button, the equipment may not enter into the Super Sleep mode and the power may be turned OFF, depending on the
state of the equipment. Refer to the TopAccess Guide for the conditions under which the equipment enters into the Super Sleep mode.
*7 [ENERGY SAVER] button on the control panel shown below.
Refer to the MFP Management Guide for changing the default settings noted above.
For the European version
Contact your service representative to change the default settings noted above.
When the set period of time for switching to the Automatic Energy Save mode and that for the Sleep mode or the Super
Sleep mode are the same, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of
time.
Conditions to enter into
modes the mode
When a particular option
is installed or when a
particular protocol
enabled.
When a particular option
is not installed and also
when a particular protocol
is disabled.
*
Status of equipment
"Saving energy - press
START button" appears on
–
the touch panel.
"Saving energy – press
*3
START button" goes off
* is and the [ENERGY SAVER]
button lights in green.
Only the MAIN POWER
*3
lamp lights.
Turning Power ON/OFF
Conditions to recover
from the mode
When a button on the
control panel is pressed
*5
or when print data or fax
data are received.
Same as the Automatic
Energy Save mode.
When the [POWER] button
is pressed and held until
the ON/OFF lamp lights,
when print data or fax
data are received through
a wired LAN or when the
time set for Scheduled
Print has come.
1
2
3
4
5
25