Command Line Interface
DGS-1210-24:admin#?
USEREXEC commands :
config account admin password <password>
config ipif System { ipaddress <ip-address> <subnet-mask> gateway <gw-
address>|
dhcp | bootp}
config ipif System { ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client {enable
| disable}}
debug info
download
<path_filenam
e 64>
logout
ping <ipaddr>
ping6 <ipv6addr>
reboot
reset config
save
show ipif
show switch
upload { firmware_toTFTP | cfg_toTFTP} {<ipaddr>|<ipv6addr>} <path_filename>
DGS-1210-24:admin#
download
Purpose
Syntax
Description
Parameters
{
firmware_fromTFTP
This command is used to download and install a firmware file, boot
file, or switch configuration file from a TFTP server.
download [firmware_fromTFTP [<ipaddr> | <ipv6addr>]
<path_filename 64> | cfg_fromTFTP [<ipaddr> | <ipv6addr>]
<path_filename 64>]
The download command downloads a firmware file, boot file, or
switch configuration file from a TFTP server.
firmware_fromTFTP – Specifies to download and install new
firmware on the Switch from a TFTP server.
<ipaddr> − Enter the IPv4 address of the TFTP server.
<ipv6addr> − Enter the IPv6 address of the TFTP server.
<path_filename 64> − Enter the filename of the firmware file or
switch configuration file on the TFTP server. You need to specify
the DOS path if the file is not in the root directory of the TFTP
server.
cfg_fromTFTP – Specifies to download a switch configuration file
from a TFTP server.
<ipaddr> − Enter the IPv4 address of the TFTP server.
<ipv6addr> − Enter the IPv6 address of the TFTP server.
<path_filename 64> − Enter the filename of the firmware file or
switch configuration file on the TFTP server. You need to specify
the DOS path if the file is not in the root directory of the TFTP
server.
D-Link Web Smart Switch User Manual
|
cfg_fromTFTP}
{<ipaddr>|<ipv6addr>}
1
0
5
1
0
5