Command Line Interface
ping6
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To ping the IP address 3FFE:2::D04D:7878:66D:E5BC:
DGS-1210-24:admin#ping6 3FFE:2::D04D:7878:66D:E5BC
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Ping Statistics for 3FFE:2::D04D:7878:66D:E5BC
Packets: Sent =5, Received =5, Lost =0
DGS-1210-24:admin#
reboot
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To reboot the Switch:
This command is used to test the IPv6 connectivity between the
Switch and other network devices.
ping6 <ipv6addr> {times <value 1-255> | size <value 1-6000> |
timeout <sec 1-99>}
The ping6 command checks if another IPv6 address is reachable
on the network. You can ping the IPv6 address through the
managed VLAN (VLAN 1 by default), as long as there is a physical
path between the Switch and the target IPv6 equipment. By
default, the Switch sends five pings to the target IPv6 address.
<ipv6addr> - Enter the IPv6 address of the host.
times <value 1-255> - Enter the ping times value here. This value
must be between 1 and 255.
size <value 1-6000> - Enter the ping size value here. This value
must be between 1 and 6000.
timeout <sec 1-99> -Enter the ping timeout value here. This value
must be between 1 and 99 seconds.
None.
This command is used to reboot the Switch. If the Switch is a
member of a stack, it may be rebooted individually, without
affecting the other members of the stack.
reboot
The reboot command reboots the Switch. All network connections
are terminated and the boot code executes.
None.
None.
1
0
1
0
D-Link Web Smart Switch User Manual
9
9