First Print - Flashforge Creator Pro Quick Start Manual

First Print

(1)
FF Creator Pro
Print from SD
Preheat
Utilities
_
ENG
Exit Menu
test model
Exit Menu
(1) Select [Print from SD]--[ENG]--[test model] successively.
(2) Next you can select the target file you want to print.
(Note: Use the left extruder to print test left. x3g while use the right extruder to print test right. x3g.)
(3) After selecting the file, press [OK] and wait for the extruder to heat. Once heated, the printer will start printing automatically.
Notes
1. You are suggested to use the left extruder to print with PLA, while the right extruder to print with ABS.
2. Load the filament for a while to extrude the melted filament out of the extruder that you printed last time.
3. Do not leave the Creator Pro unattended during operation.
4. If needed, gently use the scraper to remove the object from build plate to avoid damaging the objects and build plate. If desired,
heat the build plate to 40~50℃
to separate the object from the build plate.
5. Please preheat the heating plate to 50-70℃ for printing with PLA.
(2)
..
42mmboxleft.x3g
42mmboxright.x3g
cube.x3g
test left.x3g
test right.x3g
Exit Menu
(3)
Heating:
R Extruder: 021/220C
L Extruder: 021/220C
Plantform: 021/110C