Loading Filament - Flashforge Creator Pro Quick Start Manual

6

Loading Filament

(1) Select [Utilities] and press [OK]. Then select [Filament Loading] and
press [OK] to enter the filament loading/unloading page.
(2) Select [Load Right] or [Load Left] according to your requirement,
and the press [OK].
(3)
(1)
FF Creator Pro
Print from SD
Preheat
Utilities
Monitor Mode
Filament Loading
Preheat Settings
General Settings
(3) The extruder will be heated up automatically. Once heated,
insert the filament coming from the filament guide tube into the
filament intake. Then the filament will be drawn through the
extruder.
(4) Do not stop extruding until the filament exits the extruder steadily.
(5) Press [OK] to complete filament loading and return to the main page.
(2)
Unload right
Load right
Unload left
Load left
Heating: