Flashforge Creator Pro Quick Start Manual page 4

Unpacking
1. Open the carton and then take the top
foam sheet out.
4. Remove the packing bag. And then
remove the tape and plastic wrap for
protecting the front door.
2. Within the PE foam sheet are lying two
filament guide tubes, one piece of build
tape, one piece of Flashforge leveling
card and one Quick Start Guide.
5. The Flashforge Creator Pro and its
accessories shall be displayed in front
of you.
3. Firmly grasp the two side handles of
Flashforge Creator Pro. Lift it out from the
carton and place it on a stable surface.
6. Take the dual extruder out and place it
onto a clean ground.