Motorola MVME761-001 Installation And Use Manual page 26

4. If necessary, move some of the other modules to allow space for the
5. Install the jumper on header J1 (on the 3-row P2 adapter or header
6. Attach the P2 adapter, for either the 3-row or 5-row version, to the
Note
7. Attach the 64-conductor cable (furnished with the MVME761-0x1)
8. Attach the 64-conductor cable to connector P2 on the transition
9. Insert the transition module into the chassis slot, and tighten the
Note
10. Install the chassis cover, making sure that cables are not pinched by
11. Connect the power cable to the AC power source.
http://www.mcg.mot.com/literature
cables connected to the P2 adapter and the transition module.
J5 on the 5-row P2 adapter) if you are supporting SCSI devices.
backplane connector that is directly in line with the P2 connector on
the MVME260x, MVME270x, MVME360x, or MVME460x.
Be sure to orient pin 1 of the P2 adapter's connector with pin
1 of the backplane connector.
to the P2 adapter (J3 on the 3-row version, J4 on the 5-row version).
Be sure to orient cable pin 1 with connector pin 1.
module. Be sure to orient cable pin 1 with connector pin 1.
attaching screws.
Make sure there is good contact with the transverse mounting
rails in order to minimize RF emissions.
the cover.
Installing the Transition Module and P2 Adapter
2
2-7