Mechanical Adjustments - Pioneer DVR-RT602H-S Service Manual

1

6.5 MECHANICAL ADJUSTMENTS

1. CONFIRMATION AND ADJUSTMENT
A
Read the following NOTES before starting work.
• Place an object which weighs between 450g~500g on the
Cassette Tape to keep it steady when you want to make
the tape run without the Cassette Holder.
(Do not place an object which weighs over 500g.)
1-1: CONFIRMATION AND ADJUSTMENT OF
REEL DISK HEIGHT
B
1. Turn on the power and set to the STOP mode.
2. Set the master plane (GGF1511) and reel disk height
adjustment jig (GGF1512) on the mechanism framework,
taking care not to scratch the drum, as shown in Fig. 1-1-A.
3. While turning the reel and confirm the following points.
Check if the surface "A" of reel disk is lower than the
surface "B" of reel disk height adjustment jig (GGF1512)
and is higher than the surface "C". If it is not passed,
place the height adjustment washers and adjust to 10
(+2, -0) mm.
4. Adjust the other reel in the same way.
C
Master Plane (GGF1511)
D
Master Plane (GGF1511)
E
10 (+0.2, -0) mm
F
96
1
2
Reel Disk Height Adjustment Jig
(GGF1512)
Fig. 1-1-A
Reel Disk Height
Adjustment Jig
Reel Disk (GGF1512)
(B)
(C)
(A)
Height Adjustment Washer
2.6 × 4.7 × T0.13
2.6 × 4.7 × T0.25
Fig. 1-1-B
DVR-RT602H-S
2
3
1-2: CONFIRMATION AND ADJUSTMENT OF
TENSION POST POSITION
1. Set to the PLAY mode.
2. Adjust the adjusting section for the Tension Arm position
so that the Tension Arm top is within the standard line of
Main Chassis.
3. While turning the S Reel clockwise, confirm that the edge
of the Tension Arm is located in the position described
above.
Standard line of Main Chassis
0.5 mm (Adjustment range)
Adjusting section for the
Tension Arm position
The Tension Arm top will
move to the inside direction
Bend
of the Main Chassis.
1-3: CONFIRMATION OF PLAYBACK TORQUE
AND BACK TENSION TORQUE DURING
PLAYBACK
• USING A CASSETTE TYPE TORQUE TAPE (GGV1186)
1. After confirmation and adjustment of Tension Post
position (Refer to item 1-2), load the cassette type
torque tape (GGV1186) and set to the PLAY mode.
2. Confirm that the right meter of the torque tape indicates
50~90gf•cm during playback in SP mode.
3. Confirm that the left meter of the torque tape indicates
25~40gf•cm during playback in SP mode.
3
4
Tension Arm
Fig. 1-2-A
Tension Band
The Tension Arm top will
move to the outside direction
of the Main Chassis.
Fig. 1-2-B
4