Pioneer DVR-RT602H-S Service Manual page 124

1
(5) OSD FILTER SETTING (SUB screen 4)
Depending on the monitor used, the character flicker on the OSD may stand out.
A [Purpose]
If a system, such as charavter flicker, appears on the monitor, select the filter response.
[Tools to be used]
Remote control unit for servicing
B
[How to enter]
• While the User Operation screen is displayed, press the
key four times, in that order.
• While subscreen 3 of the first screen is displayed, press the
[How to quit]
Press the
[Setting procedures]
C
1 Display subscreen 4.
2 Select the setting from the key operation table.
[Tips]
As the setting value becomes greater, jitter is reduced on a CRT display. However, as lines for characters appear thick, complex
characters may become difficult to read. On the contrary, as the setting value becomes smaller, jitter increases on a CRT display.
However, as lines for characters become sharper, complex characters become more legible.
D
Note: Use the remote control unit for servicing.
Note: A new setting becomes active as soon as it is made. As a new setting is stored in nonvolatile memory, it will be retrieved
when the unit it turned on the next time.
Note: After the factory-preset values are downloaded, the setting value for the OSD Filter will be the default value (4).
[(Table 2) Key operation of OSD Filter setting]
Key
[ Rev x 3 ], [SPEED+] Changing the setting value for the
OSD Filter
[ x 3 Fwd], [SPEED-]
E
The setting value is reset to default.
[CLEAR]
To exit the OSD Filter Setting and
[ESC]
clear the screen (Appears the tuner
screen.)
F
124
1
2
(GGF1381)
ESC key.
Operation
DVR-RT602H-S
2
3
then
ESC
DIG/ANA
OSD Filter Setting
OSD FILTER :
Subscreen 4
Setting value
0 - 4 (Default value: 4)
–
–
3
4
keys, then the
DISP DIG/ANA
key.
4
Remarks
[ Rev x 3 ], [SPEED+]
: The setting value increases by 1.
[ x 3 Fwd ], [SPEED-]
: The setting value decreases by 1.
–
4