Power Trim And Tilt Unit Will Not Operate; Water Separator-Alert Indicator Blinks While Cruising - Yamaha VF200 Owner's Manual

Trouble Recovery
4. When replacing a fuse other than the
main fuse, remove the fuse using the
fuse puller. Install a spare fuse of the
proper amperage.
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40981

Power trim and tilt unit will not operate

If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure with
the power trim and tilt unit, the outboard motor
can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Manual valve screw
3. Tilt the outboard motor up manually to the
desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU41013
Water separator-alert indicator blinks
while cruising
EWM02542
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
Do not perform this procedure on a hot
G
or running engine. Allow the engine to
cool.
86
There will be fuel in the fuel filter. Keep
G
away from sparks, cigarettes, flames or
other sources of ignition.
Some fuel will spill during this proce-
G
dure. Catch the fuel in a rag. Wipe up any
spilled fuel immediately.
The fuel filter must be reassembled
G
carefully with the O-ring and filter cup in
place. Improper assembly or replace-
ment could result in a fuel leak, which
could result in a fire or explosion hazard.
If the water separator-alert indicator on the
Command Link tachometer blinks, perform
the following procedure.
1
1
1. Water separator-alert indicator
ZMU06962
1. Stop the engine.
2. Remove the top cowling.
3. Remove the bolts, and then remove the
fuel filter cover.
1. Bolt
2. Fuel filter cover
1
ZMU06963
1
2
1
ZMU06964