Instruments And Indicators; Digital Tachometer; Tachometer; Trim Meter - Yamaha VF200 Owner's Manual

EMU41390

Digital tachometer

The tachometer shows the engine speed and
has the following functions.
All segments of the display will light momen-
tarily after the main switch is turned on and
will return to normal thereafter.
1
3
5
6

1. Tachometer

2. Trim meter

3. Hour meter

4. Low oil pressure-alert indicator

5. Overheat-alert indicator
6. Set button
7. Mode button
EMU36050
Tachometer
The tachometer displays engine speed in
hundreds of revolutions per minute (r/min).
For example, if the tachometer display reads
"22" then the engine speed is 2200 r/min.
EMU26621
Trim meter
This meter shows the trim angle of your out-
board motor.
Memorize the trim angles that work best for
G
your boat under different conditions. Adjust
the trim angle to the desired using the pow-
er trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.

Instruments and indicators

2
EMU26651
Hour meter
This meter shows the number of hours the en-
gine has been run. It can be set to show the
total number of hours or the number of hours
4
for the current trip. The display can also be
7
ZMU01840
turned on and off.
To change the display format, press the
"
total hours or trip hours, or turn off.
To reset the trip hours, simultaneously press
the "
more than 1 second while the trip hours are
displayed. This resets the trip counter to 0 (ze-
ro).
The total number of hours the engine has
been run cannot be reset.
EMU40810
Low oil pressure-alert indicator
If oil pressure drops too low, the alert indicator
will start to blink. For further information, see
page 43.
" (mode) button. The display can show
" (set) and " " (mode) buttons for
ZMU01740
ZMU01741
31