VTrak 15100 Installation Task List
VTrak installation and setup consists of the following steps:
1.
Unpack the VTrak (below)
2.
Mount VTrak in a rack (page 5)
3.
Install disk drives (page 5)
4.
Verify the SCSI HBA Card (page 7)
5.
Connect the SCSI Cables (page 8)
6.
Set Up Network and Serial Connections (page 11)
7.
Connect the Power (page 12)
8.
Set IP Address with the Command Line Utility (page 13)
9.
Install WebPAM PRO (page 16)
10. Configure VTrak with WebPAM PRO (page 25)
Step 1: Unpack the VTrak
The VTrak box contains the following items:
•
VTrak 15100 Unit
•
Quick Start Guide
•
Null Modem Cable
•
(2) SCSI Terminators
•
Left and right mounting rails
•
There is a risk of explosion if the battery is replaced by the
incorrect type.
•
Dispose of used batteries according to the instructions that
accompany the battery.
•
(2) 1.0m External VHDCI SCSI cables
•
(64) Screws for disk drives (4 spares)
•
(2) 1.5m Power cords
•
CD with WebPAM Software, User Manual
and Quick Start Guide
Caution
3
Step 1: Unpack the VTrak