Step 7: Connect The Power - Promise Technology VTRAK 15100 Quick Start Manual

VTrak Quick Start Guide

Step 7: Connect the Power

Plug in the two power cords and switch on both power supplies. When the power
is switched on, the LEDs on the front of the VTrak will light up.
Power
Figure 7. VTrak 15100 Displays
When boot-up is finished and the VTrak is functioning normally:
• Controller LED blinks green once per second for five seconds, goes dark for
ten seconds, then blinks green once per second for five seconds again.
• Power, FRU and Logical Drive LEDs display green continuously.
• SCSI LEDs flash green if there is activity on that channel.
There are two LEDs on each drive carrier. They report the presence of power and
a disk drive, and the current condition of the drive.
Figure 8. VTrak 15100 drive carrier LEDs
After a few moments the Power/Activity and Disk Status LEDs should display
green. If there is no disk drive in the carrier, the Disk Status LED will display
green while the Power/Activity LED will remain dark.
FRU Logical Drive
Status Status
Power/
Activity
SCSI-1
Activity
Disk Status
12
SCSI-2 Controller
Activity Heartbeaty