Promise Technology VTRAK 15100 Quick Start Manual page 39

I have two UltraTraks and use WebPAM to monitor them. Can I use my
existing WebPAM setup to monitor the VTraks also?
You can use WebPAM to monitor all of your UltraTraks and VTraks. Update
your WebPAM to the version on the VTrak Software CD. Then you can
connect to each machine using the IP address of the VTrak or the UltraTrak
Host PC.
The VTrak has no LCD panel. How can I set it up and create logical drives?
There are two ways to set up VTrak and create logical drives, the Command
Line Utility and WebPAM PRO. Both are described in this Quick Start Guide.
How can I be sure everything is working OK on the VTrak?
VTrak has several LEDs on the front to monitor the status of power, field
replaceable units (FRUs) and logical drives. When these are green, VTrak is
functioning normally.
What happens if a logical drive goes critical?
On the front of VTrak, the logical drive LED turns amber and an audible
alarm sounds. This condition is described in Chapter 8 of the VTrak User
Manual on the Software CD.
Can VTrak run using just one power supply?
Yes, it is possible to run VTrak on a single power supply. There are two
power supplies so that VTrak will continue running if one of the power supply
fails. But deliberately leaving one power supply off negates this advantage.
Always switch on both power supplies.
39
Frequently Asked Questions