Connecting A Monitor (Without An Adapter); Connecting Monitors - Dell XPS 710 Owner's Manual

4. Ensure that the screw hole on the stand is aligned with the screw hole on the base of the computer.
5. Insert the captive screw into the screwhole, then tighten the screw to secure the stand to the base of the computer.
1 captive screw 2 stabilizing feet (closed)
4 slots (6)
6. With the help of an assistant, carefully set the computer upright.
7. Carefully, lift the rear of the computer and slide the stabilizing feet outward into the open position.
Connecting Monitors
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To reduce the risk of fire, electric shock, or injury, do not overload an electrical outlet, power strip, or convenience receptacle. The
total ampere rating of all products plugged into an electrical outlet, power strip, or other receptacle should not exceed 80 percent of the branch
circuit rating.
NOTE: Depending on the options selected when you purchased your computer, your video card may have two DVI ports, or one DVI and one VGA port.
1 DVI (white) connector

Connecting a Monitor (Without an Adapter)

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTE: If your monitor has a VGA connector and your computer does not have a VGA port, follow the instructions in
Adapter).
3
2 TV-OUT connector 3 VGA (blue) connector
computer stand
Connecting a Monitor (With an