Installing The Fork Protector; Removing The Lower Triple Clamp; Installing The Lower Triple Clamp - KTM 450 SXS-F Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Installing the fork protector

Removing the lower triple clamp

Installing the lower triple clamp

3 0 0 3
2 0 0 2
1 0 0 1
x
Check parts for damage and wear. Replace damaged or worn parts.
Position the fork protection on the left fork leg. Mount and tighten screws
Specification
Remaining screws, chassis
Position the fork protection on the right fork leg. Mount and tighten screws.
Specification
Remaining screws, chassis
Install the fork legs.
500105-10
x
Remove the fork legs.
Dismount the start number plate (
Dismount the front fender. (
Remove screws
Info
Do not unplug the CDI control unit.
Loosen screw
Remove screw
side.
Info
200389-10
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
Remove O-ring
Remove the lower triple clamp with the steering stem.
Remove the upper steering head bearing.
200390-10
x
Clean the bearing and sealing elements, check for damage, and grease. Replace
damaged or worn parts.
Long-life grease (
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
Info
Check whether the top steering head seal
Push up protective ring
200391-01
M6
M6
x
( P. 31)
x
( P. 30)
P. 34)
P. 33)
and hang the CDI control unit to the side.
. Remove nut with screw
, take off top triple clamp with the handlebar and place it on one
. Remove protector ring .
P. 84)
and o-ring .
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
.
is correctly positioned.
32
.