Network Configurations - Motorola CB3000 User Manual

Table 3-1. Available Networks Parameters Descriptions (continued)
Parameter
Channel
Band

3.1.2 Network Configurations

The CB3000 can be configured to run within an infrastructure (access point) type network or ad hoc (peer-to-
peer) type network, based on configured communication settings. See one of the following sections,
depending on the network type you are configuring the CB3000 to run in.
• Configuring Infrastructure Settings
• Configuring Ad Hoc Settings
3.1.2.1 Configuring Infrastructure Settings
Within the infrastructure network, the CB3000 can roam freely between access point cells in the network or
transmit and receive across subnets. Infrastructure mode is the CB3000 default mode.
To configure the CB3000 Client Bridge within an infrastructure network, follow these steps:
1. Select Settings > Wireless Settings > WLAN Settings
Settings screen displays.
2. For the Network Mode
displays.
The direct-sequence channel that the access point or peer is currently
using. The CB3000 and its connected device are required to use the same
channel to interoperate.
NOTE: Ensure the channel selected is appropriate for the intended
country of operation, or risk operating the CB3000 illegally.
The frequency band the CB3000 is operating in. Either a or b/g, for 802.11a
or 802.11b/g, respectively.
field, select Infrastructure
Description
from the CB3000 menu tree. The WLAN
(AP). The Infrastructure Configuration screen
3-3
Network Configuration