Replacing The Display Panel - Dell Latitude E4200 Service Manual

8. Lift the display panel out of the display cover and carefully lay the display panel flat on your workspace on a clean and soft type of material. Be careful to
avoid damaging the display panel with the hinges and cables on the display cover.
1 screws (4) 2 display panel
3 display cover
NOTICE: Failure to peel back the adhesive tape prior to disconnecting the display cable can cause permanent damage to the cable.
NOTICE: To avoid permanent damage to the display cable and the display panel, pull evenly on the left and right sides of the cable connector
when removing the cable.
9. Disconnect the display cable.
Peel back the adhesive tape, then pull the cable out of the connector.
1 underside of display panel 2 display cable
3 adhesive tape 4 display cable connector
Replacing the Display Panel
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
CAUTION: The tabs on the outer edges of the display panel are made of very thin metal, and could cut the skin if not handled with care.
NOTICE: To avoid permanent damage to the display panel, do not press or rub on the center of the panel.
NOTICE: To avoid permanent damage to the display panel, lift the panel using both hands on the sides of the panel.
1. Place the display panel upside down on your workspace in front of the display cover.
NOTICE: To avoid permanent damage to the display panel when connecting the display cable, insert the cable into the display panel connector by
evenly pushing the left and right edges of the cable connector. Do not grip or hold the display panel by the circuit board on the bottom edge of the
panel.