Removing The Display Bezel; Replacing The Display Bezel - Dell Latitude E4200 Service Manual

For WLAN, see Replacing the WLAN/WiMax
7. Place any unused antenna cables in the base assembly cable holders next to the card slot.
8. Replace the keyboard (see
9. Replace the LED cover (see
10. Replace the service panel (see
11. Follow the procedures in After Working on Your
Removing the Display Bezel
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1. Follow the instructions in Before Working on Your
2. Remove the service panel (see
3. Remove the LED cover (see
4. Remove the keyboard (see
5. Remove the display assembly (see
NOTICE: Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel and the display panel. Special
attention is required for the corners, especially for the bezels used with the LED display panels.
NOTICE: To avoid permanent damage to the display panel, do not press or rub on the center of the panel.
6. Starting from one side of the bezel, use your fingers to pry the inside edges of the bezel upward and outward from the display panel. Lift up on the
released side of the bezel, and continue to release the top and bottom of the bezel. Release the remaining side of the bezel last.
7. Once all snaps are released, lift the bezel from the display assembly.
1 left side of display bezel 2 top of display bezel
3 right side of display bezel 4 snaps
5 bottom of display bezel 6 display assembly
Replacing the Display Bezel
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
Card.
Replacing the Keyboard).
Replacing the LED Cover).
Replacing the Service Panel).
Computer.
Computer.
Removing the Service Panel).
Removing the LED Cover).
Removing the Keyboard).
Removing the Display Assembly).