Removing The Led Cover; Replacing The Led Cover - Dell Latitude E4200 Service Manual

Back to Contents Page
LED Cover
Dell™ Latitude™ E4200 Service Manual
Removing the LED Cover
Replacing the LED Cover
Removing the LED Cover
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1. Follow the procedures in Before Working on Your
2. Open the display all the way (160 degrees).
NOTICE: To avoid damaging the LED cover, do not lift the cover on both sides simultaneously. Removing the LED cover in a different way than
described may cause the plastic to break.
1 LED cover 2 plastic scribe
3 indent
3. Starting on the right side of the computer, use a plastic scribe (inserted into the indent) to pry up the hinge cover. Lift the bottom edge of the cover
away from the keyboard going from the right to the left, and then pull the cover up and away from the display to remove it.
Replacing the LED Cover
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTICE: Before installing the LED cover, ensure that all cables are routed correctly. Improper routing of the cables can cause damage to the
cables.
1. Insert the tabs on the top edge of the cover into the slots under the bottom edge of the display.
2. Press from left to right until the cover snaps into place, ensuring that the edges of the cover line up with those on the palm rest.
3. Follow the procedures in After Working on Your
Back to Contents Page
Computer.
Computer.