Evinrude E25RSES Operator's Manual page 62

WARNING
The outboard
installed. Failure to correctly install the
outboard could result in serious injury,
death or property damage. We strongly
recommend that your Dealer install
your outboard to ensure proper instal-
lation.
IMPORTANT: Follow all directions carefully.
The outboard's warranty will not cover prod-
uct damage or failure that results from incor-
rect outboard installation.
WARNING
Even if equipped with clamp screws,
your outboard must be bolted to the
boat to prevent it from "working off the
transom" during operation.
Center the outboard on the transom (or
mounting bracket) and tighten clamp screws
by hand.
Use the outboard stern brackets as a tem-
plate for location and size of holes to drill in
the transom.
Use each stern bracket's mounting holes as a
guide to drill TWO 5/16 in. (7.9 mm) holes
through the transom.
1
1. Drilled transom holes
must be correctly
1
007040
Use the supplied hardware to securely mount
the outboard.
Install the mounting bolts through the stern
brackets and transom. Install large washers
and locknuts onto bolts and tighten securely.
1. Large washers
2. Bolts
WARNING
When replacing bolts, screws, or other
fasteners, use Evinrude/Johnson parts
or parts of equivalent strength and
material.
I
NSTALLATION
1
2
18961
59