Trim Angle Adjustment - Evinrude E25RSES Operator's Manual

Using Your E-TEC Outboard

TRIM ANGLE ADJUSTMENT

WARNING
Boat stability and steering torque can
vary due to changing water conditions.
If any adverse conditions occur, reduce
throttle and/or adjust tilt angle to main-
tain control. If you experience boat
instability and/or high steering torque,
see your Dealer to correct these condi-
tions.
If the bow of the boat plows the water
at high speeds, the boat may bow steer
or spin suddenly, possibly ejecting or
otherwise seriously injuring occupants.
32
OK
The outboard should be perpendicular to the
water when the boat is underway at full
speed. This adjustment can only be deter-
mined by water testing the boat. Set angle ad-
justment for your normal load.
Place the outboard in full TILT position. Refer
to Tilt UP on page 31.
• Grasp the tilt rod retainer and squeeze to re-
lease. Slide rod assembly all the way out.
• Insert rod in desired position. Make sure rod
passes through both stern brackets.
• Push in against retainer. Make sure the
catch is locked on the stern bracket.
007026