Evinrude E25RSES Operator's Manual page 38

Trim
In most operating conditions, it is recom-
mended to trim the outboard to the full down
position when accelerating. Once on plane,
trim the outboard up for best performance.
Over-trimming increases engine RPM while
decreasing speed. The best trim setting is
when the highest speed is achieved with the
lowest engine RPM.
Tilt
The full tilt is often used to tilt the outboard for
clearance when beaching, mooring, or
launching.
1
1. Trim range
2. Tilt range
OK
2
007028
Tilt Lock Lever
If you intend to leave the outboard tilted for a
period of time, engage the tilt lock lever:
1) Tilt the outboard UP using the trailering tilt
switch.
2) Flip the tilt lock lever down.
3) Lower the outboard until the tilt lock lever
rests solidly on the stern brackets.
1. Tilt lock lever
When you are finished tilting the outboard,
disengage the tilt lock lever:
1) Tilt the outboard UP.
2) Flip the tilt lock lever up.
3) Lower the outboard to operating position.
T T
ILTING AND RIM
007027
1
007029
35