Evinrude E25RSES Operator's Manual page 25

Using Your E-TEC Outboard
Upon start-up, release the button.
If the engine did not start, release the button
momentarily, then try again.
IMPORTANT: Engine will not start if outboard
is in gear, if lanyard is not in place.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 55.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Engine Overheating on
page 41.
22
ENGINE STOPPING
Twist the throttle grip to SHIFT position or
slower.
Move shift lever to NEUTRAL.
Press the STOP button until the outboard
stops running. If equipped, close the vent
screw on the fuel tank's filler cap.
1. STOP button
007011
1
007012