Storing Your Honda
4. To prevent rusting the inlet valves, proceed
as follows after confirming the engine is
cool.
• Remove both seats
• Disconnect the maintenance joint.
• Start the engine at idle speed (without
pulling the throttle lever) and spray a
water-displacement corrosion-proof
lubricant (without Teflon or molybdenum
additives, such as CRC 6-56 or an
equivalent) into joint hole A for 5
seconds. Refer to the illustration of
175.
• Then immediately stop the engine.
• Perform the same procedure for joint hole
B.
• Reconnect the maintenance joint and
make sure it tightened securely.
208
Tips
(page
153).
page
NOTICE
Avoid running the engine without water flow
for more than 15 seconds to prevent severe
engine and exhaust system damage.