Honda ARX1200T3DXT3 Owner's Manual page 215

1. Flush the engine cooling system
189). After flushing, disconnect the garden
hose.
2. Remove the bilge drain plugs to drain any
water. Raise the bow (front) of your PWC
about 1 foot to allow complete draining.
3. When storing the PWC in an area where
the temperature drops below freezing,
perform the following:
• Attach a funnel onto an end of a garden
hose and connect the other end to the
flushing connector.
• Prepare approx. 5 liters of a 50/50
solution of antifreeze (Use Pro Honda HP
coolant or an equivalent).
• Following the flushing procedures for the
engine cooling system, funnel the
antifreeze solution into the engine
189).
• Keep the funnel approximately 51.2
inches (130 cm) above the deck.
(page • Check that the antifreeze solution is
(page
Storing Your Honda
coming out of the cooling water bypass
outlet and the jet pump. Use containers to
collect the solution and dispose of it in an
approved manner (page
Do not remove any containers until all
storage procedures have been completed.
51.2 inches
(130 cm)
214).
(cont'd)
207
Tips