Installing or upgrading System UI dialog
Materials required
XEROX 4635 LASER PRINTING SYSTEM—SYSTEM GENERATION GUIDE
UI Dialog software diskette.
Time required
System UI dialog installation takes about 5 minutes to complete.
Procedure
To install System UI dialog, follow these steps:
1. Insert the UI Dialog software diskette into the drive. If
needed, perform steps a. and b which follow.
a. Select "Exit to DOS" from the System Control menu.
b. Select "Yes" from the "Exit to DOS" window.
2. If A> does not display, key in A: and press <ENTER>.
3. Key in INSTALL and press <ENTER>.
4. At the "Xerox 4635/4635 MX UI Dialog Setup" window,
select "Continue".
a. At the "Xerox 4635/4635 MX UI Dialog Message"
b. At the "Xerox 4635/4635 MX PC UI System
d. At the "Destination for Xerox 4635/4635 MX UI Dialog"
e. At the "Xerox 4635/4635 MX UI Dialog Setup Exit
5. Remove the diskette from the drive. If you are performing
an upgrade, press the Reset button to finish the procedure.
SYSGEN AND SYSGEN-RELATED PROCEDURES
window, select "Continue".
Configuration" window, select "Continue".
window, select "Continue".
Message" window, select "Exit Windows".
4-3