Connection Panel - Pioneer PDP-505HD Service Manual

Connection Panel

On this unit there are 4 input systems. There are also CONTROL terminals for connection of PIONEER components with the
Î mark. For details regarding a specific connection format, refer to the page written in parenthesis.
Bottom view
4
Y
C /P C /P
B B R R
G B R HD VD
[ON SYNC] INPUT3 [H/V SYNC]
1
CONTROL IN/OUT
For connection of PIONEER components that bear the Î
mark. Making CONTROL connection enables control of
this unit as a component in a system.
2
FACTORY ADJUSTMENT TERMINAL
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
3
INPUT4
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from the
connected component.
4
INPUT3
For connection of components that have RGB or component
output jacks such as a personal computer, DVD player, or
external RGB decoder.
5
Synchronizing signal impedance selector switch
Depending on the connections made at INPUT3, it may be
necessary to set this switch to match the output impedance
of the connected component's synchronization signal.
When the output impedance of the component's
synchronization signal is above 75 Ω, set this switch to the
2.2 kΩ position.
1 2
IN OUT
FACTORY ADJUSTMENT
CONTROL TERMINAL
5 6 7
75Ωj2.2kΩ Y C /P C /P
B B R R
VIDEO
C-VIDEO
INPUT2 INPUT1
S-VIDEO
6
INPUT2
For connection of DVD player with component video
output.
7
INPUT1
For connection of components that have an S-video or
composite video output jack such as a video deck, video
camera, laser disc player, or DVD player.
Note: It is possible to have connections made to both the
VIDEO and S-VIDEO jacks at the same time. However, if
simultaneous signals are received, the S-video signal is given
priority.
8
AC INLET
Use to connect the supplied power cord to an AC
outlet.
PDP-505HD
3
ANALOG
R G B
INPUT4
8
AC INLET
97