Connection Panel - Pioneer PDP-425CMX Technical Manual

Connection Panel

When installing PDA-5003
S-VIDEO
~
When installing PDA-5004
S-VIDEO
^
IN OUT
COMBINATION
1
Plasma Display Section
1
COMBINATION IN/OUT
These connectors are used for Plasma Display
setup adjustments.
2
RS-232C
This connector is used for Plasma Display setup
adjustments.
3
AUDIO (OUTPUT) (Stereo mini jack)
Use this port to output the audio of the selected
source component that is connected to the Plasma
Display, to an AV amplifier or similar component.
Note
No sound is produced from the AUDIO (OUTPUT) jack
when the display is OFF or in the Standby mode.
4
AUDIO (INPUT1) (Stereo mini jack)
Use this port to obtain sound when INPUT1 is
selected. Connect this jack to the audio output
connector on the device that is connected to the
plasma panel's INPUT1.
5
AUDIO (INPUT2) (Stereo mini jack)
Use this port to obtain sound when INPUT2 is
selected. Connect this jack to the audio output
connector on the device connected to the Plasma
Display's INPUT2.
INPUT3 INPUT4 AUDIO
VIDEO INPUT 3/4
IN OUT R L G(ON SYNC)
! @ #
INPUT3 INPUT4
AUDIO VIDEO
R L IN OUT
& * (
RS-232C
2
INPUT5
ANALOG RGB
B R HD (H/V SYNC) VD R
$ %
COMPONENT
INPUT5
AUDIO
VIDEO
R L Y Pb/Cb Pr/Cr R
) _
OUTPUT INPUT1 INPUT2
ANALOG RGB OUT
AUDIO
AUDIO AUDIO
3 45 6
6
ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use this connector to output the video signal to an
external monitor or other component.
Note
The video signal is not output from the ANALOG RGB OUT
(INPUT1) connector when the main power of this display is
OFF or in Standby mode.
7
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
Use this input to connect components equipped
with RGB outputs jacks such as personal
computers. Verify that the connection corresponds
the signal output format from the connected
component.
8
DIGITAL RGB (INPUT2) (DVI-D jack)
Use this input to connect to a computer.
Connect to an AV component (HDCP supported)
equipped with DVI output connector.
9
SPEAKER (R) terminal
Use this port to connect an external right speaker.
Connect a speaker whose impedance is 6 Ω to 16 Ω.
0
SPEAKER (L) terminal
Use this port to connect an external left speaker.
Connect a speaker whose impedance is 6 Ω to 16 Ω.
Controls and Connectors
9 0 -
AUDIO
L
AUDIO
L
+
INPUT1 INPUT2
ANALOG RGB IN DIGITAL RGB
(D-Sub) (D-Sub) (DVI-D)
7 8
=
11