Operation
EMU30881
Trolling
EMU41832
Adjusting trolling speed
When the control lever is either in the forward position or in
the reverse position and the throttle is in the fully closed po-
sition, you can randomly adjust the trolling speed between
600 r/min and 1000 r/min by increasing or decreasing it ap-
proximately by 50 r/min. The display will show the engine
speed when the engine speed is increased from the fully
closed position during trolling speed setting mode. When
the throttle is returned to the fully closed position, the dis-
play will show the trolling speed again. When the engine is
turned off or when the engine speed exceeds 3000 r/min,
trolling speed setting mode will be released.
For details, see the attached operation manual.
TIP:
Trolling is affected by currents and other operating condi-
tions and may differ from the actual engine speed.
When warming up a cold engine, the trolling speed can-
not be decreased below the specified engine idle speed.
EMU27822
Stopping engine
Before stopping the engine, first let it cool off for a few min-
utes at idle or low speed. Stopping the engine immediately
after operating at high speed is not recommended.
55
ZMU06309
SET
CANCEL
Troll stop
MENU
ZMU07256
ZMU08536
EMU41913
Procedure for stopping engine
1.
The engine can be turned off either by pressing the
Start/Stop button or by turning the main switch to the
"
" (off) position. After the engine has been turned off
using the Start/Stop button, turn the main switch to the
"
" (off) position.
ON
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
OFF
START
ZMU06247
ON
START
ZMU04599
ZMU07171
ON
ZMU05833
ON
ON
OFF
ZMU06014