Operation
ON
START
ON
START
When starting the engine using the Start/Stop button,
press the button to start the engine. The indicator for
the starting engine will come on.
When starting the engine using the Start/Stop button on
the All Start/Stop switch panel, press the button to start
the all engines.
47
TIP:
ZMU05830
EMU36511
EMU41361
Cooling water
Check for a steady flow of water from the cooling water pilot
hole. A continuous flow of water from the cooling water pilot
hole shows that the water pump is pumping water through
the cooling water passages.
TIP:
When the engine is started, there may be a slight delay be-
ZMU05994
fore water flows from the cooling water pilot hole.
ECM02251
If water is not flowing out of the cooling water pilot hole
at all times while the engine is running, overheating and
serious damage could occur. Stop the engine and
check whether the cooling water inlet on the lower case
or the cooling water pilot hole is blocked. Consult your
Yamaha dealer if the problem cannot be located and
corrected.
ZMU07148
EMU27671
ZMU07149
EMU41811
Electric start models
After the engine has started, warm up the engine until the
engine speed settles at idling speed. The engine warming-
up indicator is shown on the Multi-Display while the engine
warms up. For further information, see page 30.
EMU36532
EMU36542
Shifting
While the boat is tightly moored, and without applying throt-
tle, confirm that the engine shifts smoothly into forward and
reverse, and back to neutral.
EMU41821
Stop switches
ZMU07150
Perform the following procedure to check that the main
When the main switch is turned to "
clip removed from the engine shut-off switch, the buzzer
will sound.
Except the single type, if the clip is not installed to the en-
gine shut-off switch, the buzzer will sound when the Start/
Stop button is pressed.
Except the single type, if one of the engines has started,
it can be stopped by pressing the Start/Stop button on the
All Start/Stop switch panel.
Checks after starting engine
Warming up engine
Checks after engine warm up
" (start) with the
ZMU05848