Table of Contents
Advertisement
Components
UP
DN
1. Power trim and tilt switch
EMU26164
Power trim and tilt switches (twin bin-
nacle type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch "
" (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switches, see
pages 64 and 66.
1
DN
UP
1. Power trim and tilt switch
TIP:
On the dual engine control, the switch on the
remote control grip controls both outboard
motors at the same time.
28
EMU30902
Variable trolling RPM switches
The trolling speed can be adjusted when the
outboard motor is trolling. Press the "
1
switch to increase the trolling speed and
press the "
speed.
ZMU08075
" (up) trims the
TIP:
The trolling speed changes approximately
If the trolling speed has been adjusted, the
For instructions on using the variable troll-
EMU26245
Trim tab with anode
EWM00841
An improperly adjusted trim tab could
cause difficult steering. Always test run af-
ZMU04601
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
" switch to decrease the trolling
1. Variable trolling RPM switch
50 r/min each time a switch is pressed.
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds ap-
proximately 3000 r/min.
ing RPM switches, see page 62.
WARNING
"
Advertisement
Table of Contents
