Yamaha VMAX VMX17 Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
1
4. Push "RESET". The multi-function
display changes to the Normal
2
mode, the stopwatch is displayed
in place of the clock, and the trans-
mission gear indicator changes to
3
the countdown clock.
5. Push "SELECT" or shift into gear
4
and the countdown clock starts
counting down from "5". Simulta-
5 neously, the shift timing indicator
flashes according to the number
displayed (i.e., when "5" is dis-
6
played, the indicator flashes five
times, when "4" is displayed, the
7
indicator flashes four times, etc.).
The stopwatch starts counting
when the countdown clock finishes
8
counting.
6. Push "SELECT" or push the start
9
switch " " to stop the countdown
clock.
7. Push "RESET" to reset the count-
down clock and stopwatch.
8. Push "RESET" to reset the count-
down clock, and then repeat steps
5–6, OR push "RESET" again for
at least two seconds to enter the
Normal mode.
TIP
To perform further multi-function dis-
play settings, be sure the transmis-
sion is in neutral, then enter the
Select mode again by pushing and
holding "SELECT" and "RESET" for at
least three seconds.
Checking and resetting the system sta-
tus
The status/readings of the following
items are displayed, and the tripmeters
can be reset.
G
tripmeters and odometer
G
fuel consumption
G air intake temperature
G throttle opening position
TIP
G The "System status" menu cannot
be entered if the fuel level warning
light or coolant temperature warn-
ing light is on.
G
If, when the engine is running
3-12
while the system status menu is
displayed, the fuel level warning
light or coolant temperature warn-
ing light comes on, the Normal
mode is automatically displayed.
1. Push "SELECT" to highlight "Sys-
tem status", then push "RESET".
2. Push "SELECT" to highlight "Yes",
then push "RESET". (Highlighting
"No" and pushing "RESET" returns
to the previous menu.)
The display changes to the status
screen.
Push "SELECT" and the various trip-
meters and the odometer are displayed