Sidestand - Yamaha FJR1300AS Owner's Manual

GEAR GEAR
N 1
HARD
HARD
+3
1. Damping force adjusting function
2. Damping force setting
3. Preload setting pictogram
WARNING
The rear shock absorber assembly
contains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
 Do not tamper with or attempt
to open the cylinder assembly.
 Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
INSTRUMENT AND CONTROL FUNCTIONS
 Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
1
damping performance.
 Do not dispose of a damaged or
2
worn-out shock absorber as-
+3
sembly yourself. Take the shock
3
absorber assembly to a Yamaha
dealer for any service.
EWA16421

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
 The built-in sidestand switch is
 The sidestand switch is also part
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
3-46
part of the ignition circuit cut-off
system, which cuts the ignition in
certain situations. (See the follow-
ing section for an explanation of
the ignition circuit cut-off system.)
of the YCC-S system. Shifting out
of neutral is impossible when the
sidestand is down.
WARNING
EAU55592
3
EWA10242