Yamaha FJR1300AS Owner's Manual page 59

While the preload is being adjusted,
the information display may change as
follows.
 If the key is turned to "OFF" or the
engine is stopped while the pre-
load is being set, the following
preload setting pictogram will
flash to alert you that the current
preload setting does not match
the pictogram. If this occurs, ad-
just the preload again.
GEAR GEAR
N N
 If the vehicle starts moving, the
following preload setting picto-
gram will flash to alert you that the
current preload setting does not
match the pictogram. If this oc-
curs, stop the vehicle and adjust
the preload again.
INSTRUMENT AND CONTROL FUNCTIONS
GEAR GEAR
N 1
HARD
+3
 If the preload is adjusted repeat-
edly, the preload setting picto-
gram will flash 4 times and the
preload cannot be adjusted. Wait
approximately 6 minutes for the
preload adjusting function motor
to cool down, and then try adjust-
ing the preload again.
GEAR GEAR
N N
3-44
Damping force
Within each preload setting there are 3
damping force settings:
(hard), "STD" (standard) and "SOFT"
(soft). When the preload setting is
changed, the damping force settings
will change accordingly. (The electron-
ically adjustable suspension system
will automatically adjust to the damp-
ing force settings last set for that pre-
load setting.) To further finely adjust
the damping force, each damping
force setting can be set to 7 different
levels.
GEAR
N
HARD
+3
1. Damping force setting
2. Damping force setting level
"HARD"
3
1
2