Sidestand - Yamaha MT10M 2020 Owner's Manual

Instrument and control functions
3. Turn the accessory off.
1
4. Insert the accessory plug into the
auxiliary DC jack.
2
3
4
5
6
1. Auxiliary DC jack
5. Turn the main switch on, and start
7
the engine. (See page 7-1.)
6. Turn the accessory on.
8
WARNING
To prevent electrical shock or
9
short-circuiting, make sure that the
cap is installed when the auxiliary
10
DC jack is not being used.
11
12

Sidestand

The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
1
cuts the ignition in certain situations.
(See the following section for an expla-
nation of the ignition circuit cut-off sys-
tem.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the sides-
EWA14361
tand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
this system regularly and have a
EAU15306 Yamaha dealer repair it if it does not
function properly.
EWA10242
5-27