Replacing A Rear Turn Signal Light Bulb - Yamaha XENTER HW151 Owner's Manual

Periodic maintenance and adjustment
1
2
3
4
1. Turn signal light bulb
5
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
6
wise until it stops.
7
NOTICE
If a turn signal light bulb of different
8
wattage than recommended is used,
the turn signal light flashing may be
affected.
9
5. Install the socket (together with the
bulb) by turning it clockwise.
10
6. Install the cowling.
11
12
Replacing a rear turn signal
1
light bulb
1. Remove the turn signal lens by re-
moving the screw.
1
ECAU0081
1. Turn signal light bulb
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
NOTICE
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
EAUT3671
ECAU0081
6-31
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
[ECA11192]