Coolant - Yamaha XENTER HW151 Owner's Manual

1
1. Final transmission oil filler cap
5. Remove the final transmission oil
drain bolt and its gasket to drain
the oil from the final transmission
case.
1
1. Final transmission oil drain bolt
6. Install the final transmission oil
drain bolt and its new gasket, and
Periodic maintenance and adjustment
then tighten the bolt to the speci-
fied torque.
Tightening torque:
Final transmission oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
7. Refill with the specified amount of
the recommended final transmis-
sion oil. WARNING! Make sure
that no foreign material enters
the final transmission case.
Make sure that no oil gets on the
tire or wheel.
[EWA11312]
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.20 L (0.21 US qt, 0.18 Imp.qt)
8. Install the final transmission oil fill-
er cap and its new O-ring, and then
tighten the oil filler cap.
9. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.
6-14

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
The coolant level should be checked as
follows before each ride. In addition,
the coolant must be changed at the in-
tervals specified in the periodic mainte-
nance and lubrication chart.
1. Place the vehicle on the center-
stand.
TIP

The coolant level must be checked
on a cold engine since the level
varies with engine temperature.

Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Open the seat. (See page 3-11.)
3. Check the coolant level in the cool-
ant reservoir.
EAU20071
1
2
3
4
EAUT3693
5
6
7
8
9
10
11
12