Air Filter And V-Belt Case Air Filter Elements - Yamaha XENTER HW151 Owner's Manual

Air filter and V-belt case air
filter elements
The air filter and V-belt case air filter el-
ements should be cleaned or replaced
at the intervals specified in the periodic
maintenance and lubrication chart.
Check both filter elements more fre-
quently if you are riding in unusually
wet or dusty areas. The air filter check
hose must be frequently checked and
cleaned if necessary.
Replacing the air filter element
1. Place the scooter on the center-
stand.
2. Remove the screw cover and air
filter case cover by removing the
screws.
Periodic maintenance and adjustment
EAUT3551
1
1. Screw cover
2. Air filter case cover
3. Air filter case drain hose
3. Pull the air filter element out.
4. Insert a new air filter element into
the air filter case. NOTICE: Make
sure that the air filter element is
properly seated in the air filter
case. The engine should never
be operated without the air filter
element installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.
5. Install the air filter case cover by in-
stalling the screws and the screw
cover.
Cleaning the air filter check hose
2
3
Cleaning the V-belt case air filter el-
ement
[ECA10482]
1. V-belt air filter case cover
6-16
1. Check the hose on the rear side of
the air filter case for accumulated
dirt or water.
2. If dirt or water is visible, remove
the hose, clean it, and then install
it.
1. Remove panel B. (See page 6-9.)
2. Remove the V-belt air filter case
cover by removing the bolts.
3. Pull the air filter element out, and
then clean it with compressed air.
NOTICE: To avoid damaging the
air filter element, handle it gen-
1
2
3
4
5
6
7
8
1
9
10
11
12